TOYMIS 2PCS Fix Sinking Office Chair, Office Chair Saver for Stop Sinking Solid Stainless Steel Adjustable Height Chair Saver Kit for Supporting The Chair in The Event Of a Cylinder Failure
Foto tomada por el comprador 0
Dinámica de precios
¿Quieres saber cuándo bajará el precio de este artículo? Haga clic en «Seguir precio» y le informaremos!
Caracteristicas
Descripción
Package Content: You will receive 2pcs 25-27mm/0.98-1.06inch chair fixing tool and a hex wrench installation tool. The office chair gas lift cylinder bracket, equipped with silicone gasket to effectively fix the chair to prevent sinking, with a wrench tool for easy installation. Premium Material: This chair fixing tool is made of high-quality 304 stainless steel, which can withstand strong pressure and is very strong. The matching silicone gasket enhances friction during use and can fix the chair to prevent sinking. Unique Design: The screw of the tool to prevent the chair from sinking can be adjusted according to different chairs. At the same time, if the cylinder fails, this office chair clip can also fix the chair from sinking, which greatly saves the cost of buying a new chair. Easy to use: This chair fixing tool is very easy to install. Just adjust the height of the chair you want before installation, unscrew the screw, install the clip on the column, put in the screw and tighten it with a wrench, the clip can be firmly fixed on the column. Wide Application: This chair fixing tool is widely used in various scenarios, you can use it to fix chairs in the office, your own home, or other places that need to be fixed.
Reseñas de productos 4
Foto tomada por el comprador 0
christine williams
I didn't check to see if all parts were there. I think this product had been returned because there was no tightening tool and one blue piece of silicone was missing.
Marko
Used to fix a chair to a specific height. Works well.
Jess Hallsworth
I have an older office chair that I can't replace the piston on. It's so comfortable, but only sits six inches off the floor. Got a couple of these fellas, installed in about 10 minutes, and now the old chair is back!Slightly limits the spin of the chair, but I can put up for that now that I have my expensive office chair back!
On3man
I've used these on a couple of old secretary's chairs I use in my craft room in the basement. They are old and I weight a lot more that their designed support weight. As a result, when I sat on them within minutes they the height piston gave up and sunk to the bottom of its travel.After putting these on the pistons, the chairs now support me at the height I am comfortable with. It took a while to get the one chair right as I did not have the clamp on tight enough. You really need to reef on the bolts to get them tight enough, but they have been working great for four months now.In case you had not realized it, these clamps fix the chair height at one position. You will loose the up and down adjustment of the chair.
Productos similares
