Red Hound Auto Power Outlet Socket Cap Compatible with Toyota (04-10 Sienna, 08-14 Sequoia, 04-10 Sienna, 07-13 Tundra, 12-14 Venza) Cigarette Lighter Plug

I was hoping to find this for my Toyota Sienna because my outlet socket was broken and hanging out for a while. It was a great relief to finally find the right size socket caps that fit and holds tightly. Highly recommend!

There are two Power Outlets in the front of the 2010 Sienna. It turns out that they are different sizes. This kit replaced the one on the right, but was much smaller than the one on the left. I would have rather purchased two different sized ones that fit right had there been any indication that was a requirement.For the one that was the right size... it can get 5 starts as installed fine and has been working fine.

I ordered a pair of these caps in part because some reviewers claimed they were OEM quality, but they are not. I was sure I could see flashing in the product video and that is the case. Flashing is the thin edges of plastic which squeezes through the gaps in the mold used to form the item. It indicates a poor quality mold and a lack of finish work. These socket caps have flashing all over them. The hinge action of the cap is uneven and doesn't have as much friction as the OEM item so the cap may fall down rather than stay open like the OEM caps. The snap lock to keep the cap in the closed position is ok as is the molded lettering on the face of the cap.Bottom line - the two pack of these caps is less than half the cost each than the OEM items from my Toyota dealer. You could certainly use them right out of the bag and they should work. More particular people will want to clean up the flashing with a sharp knife or X-Acto knife. An item like this is not likely to be closely examined once installed. Many will find these acceptable. I am more particular and use my power outlet frequently so will be returning these and will get the OEM cap because I prefer it's more sturdy feel, better finish and look, and more reliable action of the cap to stay open.

Identical to OEM part. For my 2007 Toyota Sienna, installation required me to remove the old metal lighter portion from the dead holder via the two small plastic tabs inside the metal can, open the storage compartment below the outlets, and pull the console trim piece out. Then you can install the new plastic holder into the hole in the console, slide the metal lighter thru the holder (it's keyed), and then connect the electrical thing from behind the console. Then line up the rectangular clips on the console into the holes behind and snap it back into place.

Fits great. To use, you remove old one by pushing tabs from inside old socket. Then fit this adapter to the hole in the panel. Finally fit the accessory socket into this adapter. Don't fit the adapter to the accessory socket first, or it won't fit into the panel.Also when fitting socket into the adapter, make sure the groove lines up. The accessory socket only slides one way into the adapter.